How to setup the Link 20 EHS adapter on a Toshiba DP5032 phone?
Items Required
- Jabra Wireless Headset
- Jabra Link 20 EHS Adapter
- Jabra Link 2.5mm Purple Cable (included with Link 20)
- Jabra Aux Cable (included with Link 20)
Steps
- Plug Black RJ-9 cable into the Headset jack on the Toshiba Phone
- Plug power cable into Jabra Wireless
- Compatibility setting on Base Station set to G (seems to work better on some Toshiba phones)
- Put Headset into "RHL" mode. (Press +/- at the same time > Press the black button on headset> Go to Remote Call control > Press + until you hear "GN-RHL-none" >Press +/- and then release buttons > You will hear "good bye"
- Connect Purple EHS cable with 2.5mm connector to Link 20 and mount ringtone detector to the "Bottom of Speakerphone" -close to the cradle but not on the cradle. (near darker part) on Toshiba phones.
- Now you can connect the Connect Red Aux cable from Link 20 to Aux port on Jabra Base station. (This must be the last step!!)
- Do NOT plug handset into Base Station
- To answer/disconnect Push the Multi-Function button on the Jabra wireless headset and you should hear ringtone.
- Note: If the transmit side is too low increase the transmit on the base station